Grouting Tools and Cone

To meet the growing needs of various contractors and state and federal agencies Vertek offers our self grouting tools which allow grouting of CPT holes while removing the rods. Vertek offers two types of grouting tools to fit your needs.

Non-cyceable

The Self-Grouting Module is installed in the rod string above the cone and grout is pumped right in during withdrawl. The sacrificial ring fits around the module and comes off when the rods are retracted. The design of the module does not allow for cycling and is not recommended for areas with very fine materials.

Cycleable

This Self-Grouting Module is comprised of a standard cone with blow-out plugs that allow grout to be dispensed during extraction. When the grout is pumped through the tube, the plugs are forced out and grout is released through two outlets.

Cost and Time Efficient

Verteks Self-Grouting Modules save time and labor by allowing the operator to grout the hole without extracting the rods and then filling the hole by hand. Instead, the operator can seal the hole as the rods are being retracted, and all this can be done from the operator control station.

Our self-Grouting modules run the grout tube through the center of the rods alongside the standard CPT cable through our innovative Grout Module Housing which allows the operator to run a probe, extract, and grout without work stoppage.

Grout Through Cone

A fully capable CPT Piezo Cone is AVAILABLE that enables grouting from the very bottom with a disposable tip.

Datasheet coming soon

Detailed description coming soon. Our grout cone fills in the hole while the cone is being retrieved.

Email or phone our support staff now for instant information about this popular tool.

Contact sales at 802-728-4588!

Max Tip Force:	20 Ton
Resolution:	1.1 uV
Max Sensor Input:	3.5 V
Power Requirements:	12 VDC
Tip
area:	15 cm²
range (kn):	225
range (lb):	50,000
range (mpa):	150
overload capacity:	150%
accuracy:	0.2%
Sleeve
area:	225 cm²
range (kn):	45
range (lb):	10,000
range (mpa):	2
overload capacity:	150%
accuracy:	0.5%
Pore Pressure Transducer
standard range (kpa):	6,900
standard range (psi):	500
burst pressure:	200%
accuracy:	0.5%
Inclinometer (Dual Axis)
range (degrees):	0-15
resolution (degree):	0.1
Seismic
standard tri-axial geophone true DC response capacity: (+/-):	2g
Seismic signals are gained down-hole by 1, 10, 100, or 1,000 and digitized in the DataPack no extra wires or analog measurement required